To measure ripple AC voltage, use an oscilloscope or a true RMS multimeter. Connect the oscilloscope probes across the output where the ripple voltage is presen
Read more
Electronics Engineering
What determines whether a pressure switch opens or closes on a rise of pressure?
Asked by Anonymous
A pressure switch opens or closes in response to a predefined pressure setpoint, which is determined by the internal mechanism of the switch. When the pressure
Read more
Electronics Engineering
How did the mailman show reasons and logic?
Asked by Anonymous
The mailman demonstrated reasons and logic by efficiently organizing his delivery route to ensure timely and accurate mail distribution. He prioritized letters
Read more
Electronics Engineering
What is a Macro farad?
Asked by Anonymous
A microfarad (µF) is a unit of capacitance in the metric system, equal to one-millionth of a farad (1 µF = 10^-6 F). It is commonly used to measure the capacita
Read more
Electronics Engineering
Is a tiny piece of silicon that contains millions of miniature electronic circuits by two names is called?
Asked by Anonymous
A tiny piece of silicon that contains millions of miniature electronic circuits is commonly referred to as a "microchip" or "integrated circuit&q
Read more
Electronics Engineering
Does pioneer 50wx4 mosfet in dash cd deck have esp?
Asked by Anonymous
The Pioneer 50WX4 MOSFET in-dash CD deck does not have ESP (Electronic Stability Program), as ESP is a vehicle stability control feature typically found in cars
Read more
Electronics Engineering
What is the purpose of running controls on the Clinitek status analyzer?
Asked by Anonymous
The purpose of running controls on the Clinitek Status Analyzer is to ensure the accuracy and reliability of test results. Controls are designed to verify that
Read more
Electronics Engineering
What size capacitor goes in a CK30-1T?
Asked by Anonymous
The CK30-1T typically uses a 30 µF capacitor. However, it's essential to consult the specific manufacturer's documentation or specifications for the exact requi
Read more
Electronics Engineering
What happens if the eletronmagnet if the circuit is broken?
Asked by Anonymous
If the circuit of an electromagnet is broken, the flow of electric current ceases, which results in the loss of the magnetic field generated by the electromagne
Read more
Electronics Engineering
+2
How does a high out of a cmos gate operate a cmos load?
Asked by Anonymous
In a CMOS (Complementary Metal-Oxide-Semiconductor) circuit, a high output from a CMOS gate indicates that the output transistor (typically the PMOS transistor)
Read more
Electronics Engineering
What type of digital logic gate inverts the incoming signal?
Asked by Anonymous
The digital logic gate that inverts the incoming signal is called a NOT gate. It outputs a high signal (1) when the input is low (0) and vice versa. This gate i
Read more
Electronics Engineering
Why two inputs are used in rmu?
Asked by Anonymous
Two inputs are used in a Resource Management Unit (RMU) to enhance decision-making and optimize resource allocation. The first input typically represents the de
Read more
Electronics Engineering
+1
What is the apparent rule for total resistance when resistors are added up in series?
Asked by Anonymous
The total resistance in a series circuit is simply the sum of the individual resistances of all the resistors connected in that series. This means that if you h
Read more
Electronics Engineering
What happens when you turn one of the cells around in a circuit?
Asked by Anonymous
When you turn one of the cells around in a circuit, you reverse the polarity of that cell. This can lead to a few outcomes: if the circuit is designed to handle
Read more
Electronics Engineering
Which pulse modulation scheme is used as an intermediate step in the creation of PCM?
Asked by Anonymous
The pulse amplitude modulation (PAM) scheme is used as an intermediate step in the creation of pulse code modulation (PCM). In PAM, the amplitude of discrete pu
Read more
Electronics Engineering
What is a signal 2 times the if from the desired signal that causes interference is an?
Asked by Anonymous
A signal that is 2 times the frequency of the desired signal and causes interference is known as a second harmonic or harmonic interference. This occurs because
Read more
Electronics Engineering
Design principles of function generator?
Asked by Anonymous
A: A function generator do just that output a function from any input. It can be as simple as sine wave, square wave, sawtooth, and ramp generator principle is
Read more
Electronics Engineering
Why do you snip off excess wires when soldering?
Asked by Anonymous
Snipping off excess wires when soldering helps prevent short circuits and ensures a clean, professional finish. Excess wire can create clutter, making it diffic
Read more
Electronics Engineering
+1
What do you think the voltage supplied to each circuit is?
Asked by Anonymous
The voltage supplied to each circuit typically depends on the design and requirements of the specific application. Common household circuits in the U.S. usually
Read more
Electronics Engineering
What are the three basic transistor connection configuration modes?
Asked by Anonymous
The three basic transistor connection configuration modes are common emitter, common base, and common collector. In the common emitter configuration, the emitte
Read more
Electronics Engineering
What is the conductor of 5 ohms?
Asked by Anonymous
A conductor with a resistance of 5 ohms allows electric current to flow through it with relatively low resistance. The specific materials and dimensions of the
Read more
Electronics Engineering
How is the data rate for PCM digital voice signals 64 Kbps calculated?
Asked by Anonymous
The data rate for Pulse Code Modulation (PCM) digital voice signals is calculated using the formula: Data Rate = Sampling Rate × Bits per Sample. For standard v
Read more
Electronics Engineering
What is bias through use of names?
Asked by Anonymous
Bias through the use of names refers to the preconceived notions or stereotypes that individuals may hold based on a person's name. This can lead to assumptions
Read more
Electronics Engineering
+1
How much current flows through a 16 V battery that has a resistance of 5.1?
Asked by Anonymous
To find the current flowing through a 16 V battery with a resistance of 5.1 ohms, you can use Ohm's Law, which states that current (I) equals voltage (V) divide
Read more
Electronics Engineering
How is 0.016 k ohms stated?
Asked by Anonymous
0.016 k ohms can be stated as 16 ohms. This is because "k" stands for kilo, which is a factor of 1,000, so 0.016 k ohms is equivalent to 0.016 × 1,000
Read more
PreviousNext
Trending Questions
What is the resistance of the circuit if current flow is 6 amperes in a 120-V circuit? What is the effect of the reverse bias on the width of the PN junction? What frequency range does the US use for FM broadcasting? Why transistor have 4 wire? In a color television set using a picture tube a high voltage is used to accelerate electron beams to light the screen That voltage is about? What is soft fast recovery diode? What is the beacon frequency of INST AA? Applications of hybrid pi model of bjt? Can you use a 6A 250v fast blow fuse instead of a 6.3A 250v fast blow in a 250 volt amplifier? How do you increase the value of a capacitor? What are the advantages and disadvantages of adaptive routing? The average power dissipated by a resistor connected to a sinusoidal emf is 7.0W. What is P avg if the resistance R is doubled? What do digital circuits mostly use? Where are tools and equipment should be stored and located and the importance of returning all tools and documentation to their designated area on completion of work activities? How many ohm is a mega ohm? Does the area of a solar cell effect the voltage output? What unit awards are authorized to wear in the 2 scr? List out different telecom technologies? How hysteresis comparator works? What is the advantage of a bidirectional cable amplifier over a unidirectional cable amplifier?
Still have questions?
Find more answers
Previously Viewed
How is our soul consciousness connected to the flow of time? How do use the word Consciousness in a sentence? What are Freuds three levels of consciousness? When was International Society for Krishna Consciousness created? How do drug affect consciousness?
Resources
Leaderboard All Tags Unanswered
Top Categories
Algebra Chemistry Biology World History English Language Arts Psychology Computer Science Economics
Product
Community Guidelines Honor Code Flashcard Maker Study Guides Math Solver FAQ
Company
About Us Contact Us Terms of Use Privacy Policy Disclaimer Cookie Policy IP Issues Cookie Settings
Copyright ©2025 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.